Page 381 of 381 FirstFirst ... 131 281 331 356 371 372 373 374 375 376 377 378 379 380 381
Results 7,601 to 7,613 of 7613

Thread: Bush Lapa mods

  1. #7601
    Join Date
    Apr 2008
    Location
    Secunda
    Age
    40
    Posts
    975
    Thanked: 352

    Default Re: Bush Lapa mods

    I have experienced the same and as mentioned above blocks work to stop the rolling of the wheels
    However, I use my stabilizer in conjunction with the jockey wheel - the jack takes a lot of weight of the wheel and thus amounts to the same end goal of saving the jockey wheel

    Works well for me and provides stability for the from when kids are on the bed
    2013 Toyota Hilux 3.0D4-D 4x4
    Bush Lapa 810 Miskruier

  2. #7602
    Join Date
    Sep 2006
    Location
    Durbanville
    Posts
    4,754
    Thanked: 2874

    Default Re: Bush Lapa mods

    Here enters the benefit of the Al-ko jacks. In this pic the jockey is simply touching the ground, but has no pressure on.

    The BL stabilizer on the A-frame - the intent is not to replace the jockey, but simply to add support in conjunction with the jockey wheel. The stabilizer alone will create a pivot point.
    Attached Images Attached Images  
    Last edited by George; 2021/09/14 at 10:49 AM.
    Disclaimer - All my posts on this forum is without prejudice, is based on my fair assumptions or perceptions, might not be factually correct, is in no way intended to cause harm to anyone and is acted upon at your own discretion.

  3. The Following 2 Users Say Thank You to George For This Useful Post:


  4. #7603
    Join Date
    May 2016
    Location
    Mossel Bay
    Age
    46
    Posts
    68
    Thanked: 27

    Default Re: Bush Lapa mods

    Ek het nie daai Alko jacks op my 2014 Miskruier gehad nie ma het dit gesien op ander Bushlapa's.
    Met nuwe Kewer het ek dit laat opsit en dit werk briljant, maak die wa baie meer stabiel binne, nie meer daar "gewieg" nie.
    Martin vir my opgesit en dit was ook nie so baie nie, was onder die R2800 as ek kan onthou met instalasie.
    2017 TOYOTA FORTUNER 2.8 4X4
    2014 BUSHLAPA 350 MISKRUIER

  5. #7604
    Join Date
    Sep 2006
    Location
    Durbanville
    Posts
    4,754
    Thanked: 2874

    Default Re: Bush Lapa mods

    Direk by Al-ko is hulle so R800 per kant. So uur se werk om dit te installeer.
    Disclaimer - All my posts on this forum is without prejudice, is based on my fair assumptions or perceptions, might not be factually correct, is in no way intended to cause harm to anyone and is acted upon at your own discretion.

  6. #7605
    Join Date
    Dec 2006
    Location
    Somerset West
    Age
    60
    Posts
    640
    Thanked: 184

    Default Re: Bush Lapa mods

    Quote Originally Posted by George View Post
    Direk by Al-ko is hulle so R800 per kant. So uur se werk om dit te installeer.
    Het jy dalk fotos van die 'mounting points' asseblief.

  7. #7606
    Join Date
    Nov 2010
    Location
    Cape Town
    Age
    62
    Posts
    95
    Thanked: 63

    Default Re: Bush Lapa mods

    Quote Originally Posted by TimTDP View Post
    I am looking for a solution for my Boskriek shower. Shower water creates a lot of mud. Also want to be able to dump water away from BL.
    Would like a mod to keep shower area mud free, and easy water disposal
    Thanks in advance
    Hi Swambo makes these to order out of canvass, they roll up flat with a size of 1200mm long, 130mm wide and 30mm thick

    Please contact Tracy on 0832680042 for furtjher details

    also see https://www.gumtree.co.za/a-camping-...00910393168509
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	quickpitch basin 2.jpg 
Views:	138 
Size:	118.2 KB 
ID:	629925   Click image for larger version. 

Name:	gogga3.jpg 
Views:	137 
Size:	192.3 KB 
ID:	629926   Click image for larger version. 

Name:	IMG_9349.jpg 
Views:	134 
Size:	318.4 KB 
ID:	629927  
    Putta
    Landcruiser 105
    BL Miskruier B850

  8. The Following 5 Users Say Thank You to putta For This Useful Post:


  9. #7607
    Join Date
    Sep 2006
    Location
    Durbanville
    Posts
    4,754
    Thanked: 2874

    Default Re: Bush Lapa mods

    Quote Originally Posted by Sebastiaan View Post
    Het jy dalk fotos van die 'mounting points' asseblief.
    Op die T waar die chassis sterk is. Daar is 2 grootte jacks beskilbaar. Vir die Goggas, kry die korter een sodat hy vertikaal kan opvou langs die chassis.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	Resizer_16316793267420.jpg 
Views:	122 
Size:	230.4 KB 
ID:	629936   Click image for larger version. 

Name:	Resizer_16316791374202.jpg 
Views:	121 
Size:	236.1 KB 
ID:	629937   Click image for larger version. 

Name:	Resizer_16316791374201.jpg 
Views:	117 
Size:	148.6 KB 
ID:	629938   Click image for larger version. 

Name:	Resizer_16316791374200.jpg 
Views:	116 
Size:	160.5 KB 
ID:	629939  
    Last edited by George; 2021/09/15 at 06:18 AM.
    Disclaimer - All my posts on this forum is without prejudice, is based on my fair assumptions or perceptions, might not be factually correct, is in no way intended to cause harm to anyone and is acted upon at your own discretion.

  10. The Following User Says Thank You to George For This Useful Post:


  11. #7608
    Join Date
    Apr 2008
    Location
    Secunda
    Age
    40
    Posts
    975
    Thanked: 352

    Default Re: Bush Lapa mods

    Busy installing a Victron BMV-712 battery monitor in my Miskruier B810. Looking at a few options of where to install (fasten) the shunt that needs to connect between the battery negative and the load an charger negatives. With everything else close by and already in the battery box I m think of somewhere under the side bed close to current battery installation. Where is the shunt on the newer models or any other similar mod done? Suggestions?
    Attached Images Attached Images  
    2013 Toyota Hilux 3.0D4-D 4x4
    Bush Lapa 810 Miskruier

  12. #7609
    Join Date
    Nov 2013
    Location
    PE & North Africa
    Posts
    803
    Thanked: 505

    Default Re: Bush Lapa mods

    Quote Originally Posted by Hilux01 View Post
    Busy installing a Victron BMV-712 battery monitor in my Miskruier B810. Looking at a few options of where to install (fasten) the shunt that needs to connect between the battery negative and the load an charger negatives. With everything else close by and already in the battery box I m think of somewhere under the side bed close to current battery installation. Where is the shunt on the newer models or any other similar mod done? Suggestions?
    Hallo Henk,

    Hier het BL myne gesit, op die voorkant van mudguard onder die bed.

    Cheers
    Attached Images Attached Images  
    Last edited by Grumbles; 2021/09/18 at 10:15 PM.
    2021 Hilux Raider 2.8 GD-6 4x4 D/C Auto "Luxy"
    2018 Baobab 4 - B1543 "Nala"


    Bacon fact #16 - Bacon is healthier than Crystal Meth!



  13. #7610
    Join Date
    Apr 2008
    Location
    Secunda
    Age
    40
    Posts
    975
    Thanked: 352

    Default Re: Bush Lapa mods

    Right so the shunt of the Victron BMV-712 is fitted and connected. Rivotted it on the lip of the lid below the side bed next to the batteries. Sorted the app and now playing with solar etc details and history. Fantastic product. Ill get a 52mm steel hole saw and fit the monitor to the DB board, replacing the Hella plug this week sonewhere.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	IMG-20210919-WA0000.jpg 
Views:	58 
Size:	37.5 KB 
ID:	630423   Click image for larger version. 

Name:	IMG-20210919-WA0002.jpg 
Views:	54 
Size:	30.5 KB 
ID:	630424   Click image for larger version. 

Name:	Screenshot_20210919-133708.jpg 
Views:	57 
Size:	92.1 KB 
ID:	630425  
    2013 Toyota Hilux 3.0D4-D 4x4
    Bush Lapa 810 Miskruier

  14. #7611
    Join Date
    Sep 2006
    Location
    Loevenstein, Bellville
    Age
    41
    Posts
    2,537
    Thanked: 529

    Default Re: Bush Lapa mods

    Quote Originally Posted by Hilux01 View Post
    Right so the shunt of the Victron BMV-712 is fitted and connected. Rivotted it on the lip of the lid below the side bed next to the batteries. Sorted the app and now playing with solar etc details and history. Fantastic product. Ill get a 52mm steel hole saw and fit the monitor to the DB board, replacing the Hella plug this week sonewhere.
    Looks like a very cool gadget and I love things like this but sheez it's expensive.
    Niel
    2012 BMW F800GS
    2010 Nissan Navara 2.5 dCi 4x4
    2015 Bush Lapa Miskruier (B503)

  15. #7612
    Join Date
    Apr 2008
    Location
    Secunda
    Age
    40
    Posts
    975
    Thanked: 352

    Default Re: Bush Lapa mods

    Ok so monitor fitted to DB. Never want to drill a 52mm hole in my BL again 🥶😀
    Attached Images Attached Images  
    2013 Toyota Hilux 3.0D4-D 4x4
    Bush Lapa 810 Miskruier

  16. The Following 2 Users Say Thank You to Hilux01 For This Useful Post:


  17. #7613
    Join Date
    Mar 2011
    Location
    Springbok
    Age
    55
    Posts
    72
    Thanked: 33

    Default Re: Bush Lapa mods

    Quote Originally Posted by Hilux01 View Post
    Ok so monitor fitted to DB. Never want to drill a 52mm hole in my BL again
    Very nice, although, to avoid the stress and work just replace your batteries with a BT lithium. 1) You can track the SOC on your cellphone 2) Your BL will be around 30 kg lighter and 3) you free up space in the load bin

Similar Threads

  1. 3 Bush Lapa Miskruiers in one spot!
    By Kooskop in forum Trailers, Caravans, Towing etc
    Replies: 38
    Last Post: 2021/02/26, 04:24 PM
  2. Project Venter Bush Baby: first impressions
    By coala in forum Trailers, Caravans, Towing etc
    Replies: 21
    Last Post: 2014/10/28, 06:57 AM
  3. Bush Lapa Miskruier featured in.....
    By Kooskop in forum Trailers, Caravans, Towing etc
    Replies: 0
    Last Post: 2011/10/03, 03:18 PM
  4. Kyknet Buitelug Expo - Bush Lapa range
    By Kooskop in forum Trailers, Caravans, Towing etc
    Replies: 8
    Last Post: 2011/09/29, 08:20 PM
  5. Performance mods on TD's
    By 280iNyati in forum Vehicle & Technical Chat - General
    Replies: 0
    Last Post: 2006/09/12, 10:39 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •