Search:

Yep, I redid my learners and license last month. Took 2 weeks to get the EB from learners to test here in CT.

Thanks, will take a look at these locations for the leak and fault in the wiring!

For what it's worth, Conqueror Wellington is no longer affiliated with Conqueror the manufacturers. I believe they changed their name too. This is due to a number of issues raised by disgruntled...

Trip went well! Towing was comfortable and really had nothing to worry about.

Ran in to a few issues with the Companion though. The water is spluttering out the taps. I checked the inlet pipe...

Vloedbos for the "long weekend" trying out our Conqueror Companion for the first time ;D

Ok great, I'll do that this weekend with the Jik.

Very interesting info, thanks! I'll travel empty then

Appreciate the advice, makes me feel a lot more comfortable!

Thanks for advice. I've seen a couple thread that say Conqueror recommends to tow with the tank full. Unsure of the exact reasoning.

Will make sure to pack balanced and drive around ~110km/h.
...

Thanks for the advice! When I fetched the trailer I also noticed a bit of rocking from side to side. Happy to hear that is normal. Will be sure to check shocks, tyres, brakes etc.

Is there a...

I've recently purchased a second hand Conqueror Companion. We're about to do 2 trips. First, a "test" weekend away next week where we hope to learn a bit about the Companion and figure out...

I really enjoyed reading your trip report! The highs and lows.

Botswana is my bucket list destination that I've been wanting to do for ages. I'm planning a trip for next year. We have 3 kids (3,...

I've got the same issue. 2cm lower front left (haven't measured the back, but I will). I put it down to my recent suspension replacement that I did directly after purchase and it's going in shortly...

I just booked 11 days camping in Letaba during the middle of the school holidays, even though there is basically no camping availability in the park at the moment.

The trick is to register on the...

Little earlier this year in the Kruger.

658197

Just got my EB. Took just under 2 weeks from when I got my learners. 5 lessons with Alpha Driving school (Henri) in CT and I was sorted. Milnerton had a lot of availability for test bookings. Glad to...

So I opened the panel below the switch board and found a number of different cables have become disconnected at the lugs. Some are using spades and others are using plastic automotive cable...

That was my thinking. I'll have a look when I get some time this week and hopefully can figure it out without having to take it in.

Yes they are :-\ Little bit frustrating as "everything is in good working order" when I bought it... Guess I will have to take it in.

Sorry for bringing back a thread from the dead :)

I just bought a second hand 2012 Companion. When I plug in the 220V to the side of the trailer, nothing happens. No lights on the board...

Do you have a lift or spacers? Is it only rubbing at full tilt or before full tilt?

Obviously I have a slightly different vehicle, but have All Terrain BFG and when the 50mm lift is not 100% (i.e...

I've done this on my Fortuner. Added a 50mm lift as well with air helpers. When the air helpers are soft, I have slight rubbing on the front right hand side (I think on the mud flap). Other than...

I did a 50mm lift and put new mags and BFG tyres (bigger size than standard) on my Fortuner. I experience a vibration when pulling off and it seems to be the angle of the propshaft in to the centre...

Thanks! I will check out the centre bearing for any play shortly.

I also just found this which is interesting: https://www.youtube.com/watch?v=6RGAOfoa254&t=59s Looks like some folks use spacers...

I had AmadaXtreme suspension added to my Fortuner and air helpers installed too. The suspension gave the vehicle a ~50mm lift.

Long story short, the air helpers seem to have a slow leak. When they...

Couldn't have seen this at a better time!

I'm going to be building something very similar this weekend for an upcoming Kruger trip. 3 kids, so want to keep the extra back seats in for when they...

Thanks!

Don't have his number, but will try PM him.

Regards,
Matt

Hi all,

This may be a long shot, but I thought I'd try anyway...

I have a 2004 TD4 Freelander that needs its timing chains, tensioner, guides and sprockets replaced.

The parts locally are...

I just bought a FL1 last week, 2004 TD4. Loving it so far :)

After being ripped off by LandyTech and a bunch of other "indies", Albert was a breath of fresh air. My next Landy will go no where else other than Alberts garage! Nothing but excellent service from...

I picked one up for R800 with winch plate, a place for spots and branch deflectors. Very nice bullbar worth at least R6k new! Had a little damage that I got repaired for ±R1000 :) Keep an eye out on...

Definitely agree with the above. If it were not for this forum and fellow Landy guys on here, owning my first Land Rover would have been a lot more difficult!!

Another person who goes above and...

Mine is extremely heavy! Makes driving in traffic quite difficult hehe... On the plus side, my leg is getting really strong. Just have to work out the other one harder in the gym.

Thanks for the...

Awesome Landy! Congrats, you're gonna love it! ;D

In my view, it would only be fair to ask Eric to pay for the damages if it was specified that the nuts need to be tightened or checked every x amount of kilo's in the cars maintenance list that was...