Search:

The thing about kinetic recoveries are that people do this first, instead of as a last resort.

People are lazy.

The hijacking hotspot and my two colleagues being robbed is within the last month.

I'm just giving you my perspective, I don't live there.

But I've been in this area since 1997.

Oh, I built one a few years ago.

664279

664280

Vredenburg is going down hill.
A part of the road to the West Coast Mall coming from the town is now a hijack hotspot.
Also a few hijackings at the robot when entering the town, a few years ago.
...

If it's flat glass, any reputable glass place will be able to help you.

If not, maybe Isuzu only.

Could be a failed diode in the rectifier.

A bolt cut on a lathe will always be inferior to a rolled bolt, unless properly heat treated.

Replace the spring with one from a V8 valve spring.

Why not buy directly from Awesome Tools and courier it.

Here's the one I had.

663540

It's a tracking device, I had basically the same one.

Then maybe this?


http://www.isuzupup.com/viewtopic.php?t=18376

Maybe this could help:

https://www.4x4community.co.za/forum/showthread.php/190883-High-Idle

Yes, that one.

So after finding a leak at the Y-piece, I decided to finally install the brass one.

The original one was still fine, the leak was more about the rubber pipe diameter and the pipe clamps, but I...

It should turn freely with no compression.

You will need more leverage if it's fully assembled.

Then it's either a wire or the sender unit.

I'll check the wiring first.

Plank + badkamerskaal+ jockywheel = you know what's what.

Very rare and only available in SA.

Sought after in the UK and maybe US.

Nice attention to detail.

BTW I might still have 2 brand new ones somewhere if you are interested.

Some RTV sealant
Extra set of points and condenser
Oil for engine
Maybe a spare electric fuel pump

A manual on your phone.


Enjoy.

Yes please.

This should have been done via PM.

Oh this is a bit lost in translation.

I thought this is the African Wild Cat:

662281

But I see what you are saying.

It could be a possibility.

As I don't have a picture from the side, it's a possibility, but the legs are very short.

Compare it to the Mongoose.

So we set up the trail camera over the holidays, 3 or 4 weeks and found some new animals at the same spot.

First the regulars:

662261

662259

662260

Sucking it out will most probably be the cheapest option.

The reservoir become brittle after a few years and the grommets might be too stiff for pushing it back in.

The grommets can also leak...

Not just any grease, it's called one shot. One per swivel housing.

Here's a picture and a link:


661314

...

Check out Brittanica restoration on YouTube.

He recently did a few videos on brake pipes and building them.

I would recommend watching it before you buy stuff.

You should let the aircraft stand for 24 hours, for the water to settle at the bottom, where the purging points are.

Jeremy Clarkson proved that, in the UK, it's cheaper to post a bicycle from the southern point to the northern point than having it on top of the vehicle.

Due to air resistance increasing fuel...

Ja, I love camping in the winter.


Especially in the Kgalagadi.

I once got there and was the only one with long pants.
Almost cut them down to length.

That's beautiful!

Ignoring a universal can lead to bigger damage.

I've seen one rip off the rear end from an Isuzu gearbox.

So take it easy but fix it soon.

Push rods. (Not all straight)