Search:

A set of custom sliders built for a 80 series sliders.


656910

656765


656766

Definitely!

The pump packed up again -same O-ring. It became brittle and is leaking so that you have to rev over 2000 rpm for the lift to work. I took the whole pump apart and the front seal is also gone and...

www.stofpad4x4.co.za

which engine model?

Ry battery centre toe - laat hulle vir jou n stel opmaak.

Final product:

655823


655824

655825

Obviously not a bumper, but an ongoing installation:

655765

What warranty? Entire one - so engine failure blamed on a reverse camera? Or just for the radio?

Ek het hom toe gister aand gemodelleer en "just as well"; daar is een of twee ontwerps veranderinge wat ek aan die ander dele wil maak om die te maak pas:

655636



655637


655638

Nee, die bakkie het n bumper gekry want die eienaar se dogter het die bakkie se hoek so bietjie gedruk met die OEM bumper.

I installed this new Ranger bumper yesterday - quick 45min fitment.

655170



655171


655172

https://joliens-rest-camp.business.site/

Wheel size and clearance fixed up. 32" tyre with 140mm clearance to the wheel arch.

655070

Honestly: I'll worry about that when I get there.......

Thank you - I appreciate the compliment. Sometimes I suspect the design is more of a thrill than the build itself.




The 3D model shows 28"tyres, I will use 32" - I'll have to update that to...

No, I still have to include those. I will use dummies for now with estimated weights to determin the CoG of a complete tralier.

I love the Chinese hat idea! definitely going to steal that.

Ja, maar dan raak hy baie swaar voor. Jy kan dan die as weer vorentoe skuif, maar die lang "as afstand" gee stabiliteit

The CoG is shown in post 59. Some weight will be still be added behind the wheels.

Ja, die chassis moet nog ontwerp word. Hy sal verseker tie-downs, recovery punte en n receiver he.

I am not planning a lot of water storage, so the spare will go underneath. I'll get a hoist from a bakkie a scrapyard to fit in there.

The axle is not in the correct position right now, one of the mates in SolidWorks flipped to the wrong side. So I am planning a sub frame below the main frame and rubber mounts between the two to...

Unfortunately the model of the Hilux doesn't have that much detail.

I was actually referring to the sealing on doors - to keep water/dust out.

Yip! Side door and slide!

Please criticize! I need ideas/problems etc to come out now.

Yellow is an internal drawer - it slides out into the trailer and will carry mostly clothes.

Pink/purple is the kitchen - slides out to the side.

654611

Behind the kitchen 700mm of space...

The frame design is done - I still need to figure out what type of floor to install- and how to fix this to the chassis.

654610

This pump and engine was stolen before I could even use it once. So a new system needs to be built - on a separate frame which will be removed and stored as safely as possible to prevent theft...

Whow!!! How did I miss this fred? I am certainly subscribed now.

I have so many questions:


How does your sealing solution look? I have posted some images of my sealing concept here:
...

I would wash it properly, remove all rust and re-paint with high temp paint.

Never been off-road?

We have stock - just need assembling

[email protected]

Ask for a FC111.

www.stofpad4x4.co.za

http://www.stofpad4x4.co.za/product/fc126/ford-ranger-rear-bumper

Is dit die een wat in Kimberly te koop was?