Search:

Type: Posts; User: clivemd; Keyword(s):

Page 1 of 29 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    4,873
    Views
    826,620

    Defender Re: What have you done with your Defender today?

    Nearly finished my canopy
  2. Replies
    26
    Views
    1,010

    Re: My Disco 1 LT230 Transfer box rebuild thread

    Hopfully it will be ok, we have gone to 85W-140 oil now on are T-cases and Diffs
  3. Replies
    11
    Views
    576

    Re: land Rover Diagnostic Tools

    Some phone OBD will just read what going on, if you want to get into ecu change IS10 program remotes, injector codes, load maps and so on then the Nanocom is the way to go, end day it depends what...
  4. Replies
    4
    Views
    274

    Re: Defender steering wheel replacement

    yes it is, if I had the extra cash I would of got the quick release boss
  5. Replies
    4
    Views
    274

    Re: Defender steering wheel replacement

    Got mine from UK from Mudstuff.co.uk has the pins on the boss for the indicators, depending on defender you get 48 and think it 36 spline, mine was 48 spline,
  6. Replies
    8
    Views
    385

    Defender Re: td5 injector washers

    Also I would only use original LandRover washers and O rings
  7. Replies
    26
    Views
    1,010

    Re: My Disco 1 LT230 Transfer box rebuild thread

    I donít use the paper gaskets just sealant vitor renz ( spelling) and on the bolt threads I use Wurth PTFE pipe sealant, and use Tinken bearings
    have you got the LT230 manual
  8. Replies
    26
    Views
    1,010

    Re: My Disco 1 LT230 Transfer box rebuild thread

    Oh and for the input seal get a viton seal they take the heat better then normal ones
  9. Replies
    26
    Views
    1,010

    Re: My Disco 1 LT230 Transfer box rebuild thread

    Are those copper it could be from the center diff spider gears shims only thing that is copper in the LT230,
    if you strip it you will need a new crush tube for the intermediate gear, if you change...
  10. Replies
    514
    Views
    62,751

    Re: Ineos Grenadier revealed!!

    Looks like all those cap screws are just part of the mold to make it look like that, as each section is made to look seperate but it one big mould face plate,
    good that they have pre wired extra...
  11. Replies
    41
    Views
    1,675

    Defender Re: TD5 oil pressure drops when hot, any ideas?

    I have a temp sensor tapped into the sump and the reading are between 90-100normal and on long uphills and so on can get upto 120
  12. Replies
    19
    Views
    828

    Discovery 2: Re: Allisport in South Africa

    Rovertec in Westmead might have try them
  13. Replies
    19
    Views
    828

    Discovery 2: Re: Allisport in South Africa

    What car is it for
  14. Replies
    19
    Views
    828

    Discovery 2: Re: Allisport in South Africa

    No agents you have to bye on line and DHL it out
    ie it for TD5 defender or disco
  15. Replies
    26
    Views
    1,013

    Defender Re: Steering Box Oil Leak

    Have you tried LR service center they have a seal kit but donít know if that seal is in the kit
  16. Replies
    31
    Views
    2,259

    Re: Discovery V8 mysterious engine noise

    Donít know if your crank dampener is like the TD5 that has a bearing in it and the bearing can start to fail and make a knoise before it fails
  17. Replies
    41
    Views
    1,675

    Defender Re: TD5 oil pressure drops when hot, any ideas?

    Any updates on this
  18. Replies
    11
    Views
    580

    Re: Compound to fill gaps

    I use this stuff from Wurth and also use in in the corner of the windows to stop water leaking down the joins

    it like a putty but does not go hard

    i also use the Wurth seam sealer for all the...
  19. Replies
    31
    Views
    1,733

    Re: Oil Filter replacement

    These are very good have one
  20. Replies
    31
    Views
    1,733

    Re: Oil Filter replacement

    Have done it plenty times and yes it can make a mess of the filter but it works
  21. Replies
    31
    Views
    1,733

    Re: Oil Filter replacement

    Should be ok, how much access to the filter have you, can you smack a screw driver in filter and use it as a leaver to loosen, then again you donít want it with a hole and then canít get it off and...
  22. Re: Would you recon, secondhand or new for gearbox?

    I rebuilt mine think the rebuilt kit from Ashcrofts was 11k landed I also put new oil pump in as well and a shim kit, shimming the bearings is very important to get pre load, seen them not done...
  23. Replies
    41
    Views
    1,675

    Defender Re: TD5 oil pressure drops when hot, any ideas?

    how did the open PRV destroy the engines as you say was it due to now dirty oil circulating
  24. Replies
    41
    Views
    1,675

    Defender Re: TD5 oil pressure drops when hot, any ideas?

    When you say filter went to bypass and destroyed engines, that must only be couse of dirty oil circulating as with it stuck open the engine will still have oil pressure
  25. Replies
    11
    Views
    5,553

    Re: Racor diesel fuel filter

    Been using a Parker Racor filter R13S which is 2 Micron and a 10 Micron pre filter on my 300TDi never had a problem
  26. Replies
    31
    Views
    1,837

    Re: Defender 110 V8 how much

    Rust that is what have to check out now how bad is it, firewall, doors cos it it is bad there you could be in for big money fixing or replacing those parts area,
  27. Replies
    125
    Views
    14,622

    Re: Puma D/Cab Build thread

    glad all came together, if you still thinking about the old parts can you send me pics
    thanks
    Clive
  28. Replies
    108
    Views
    19,134

    Re: Defender with Ashcroft ATB's

    I know how to use my CDL
  29. Replies
    568
    Views
    160,449

    Sticky: Re: LR parts offered / required

    Looking for a Defender TD5 fan speed decal not the 300TDi sticker kind

    thanks
  30. Replies
    3
    Views
    273

    Defender Re: Defender hydroboost brake conversion

    All my defenders have had good brakes, only time they started to get bad was becouse the booster starts to get hair line cracks around the 2 studs that hold the master, and then can not hold vacuume...
  31. Replies
    125
    Views
    14,622

    Re: Puma D/Cab Build thread

    What did you do with old roof and parts, my son looking to go other way from DC to CSW we might of found a roof
  32. Replies
    5
    Views
    432

    Re: Oil for T-case, diffs and gearbox

    I use that in my transfer case as I have a overdrive and has Bronze cyncro so use GL4 normally use EP90 GL5 with T case and Diffs as GL5 is better for Diffs I am using 140 in my Diffs with lockers
    ...
  33. Replies
    125
    Views
    14,622

    Re: Puma D/Cab Build thread

    My rock sliders I ended up galvanizing and then primed and used Raptor paint,
  34. Replies
    108
    Views
    19,134

    Re: Defender with Ashcroft ATB's

    I personally would not rather spend the 1300 and get one think Landy guru in CT sell them
  35. Replies
    125
    Views
    14,622

    Re: Puma D/Cab Build thread

    Rubberizing that is one thing I canít stand on a Landy, seen some very nice Landies only to have rubberizing inside and the bin it Madness
Results 1 to 35 of 999
Page 1 of 29 1 2 3 4